No products in the cart.
Black mineral-filled epoxy resin for hot mounting. Provides the best possible embedding result with low shrinkage and best edge retention.
Dia., force, heating/cooling time:
25 mm: 10 kN, 3-5 min/2-3 min
30 mm: 20 kN, 3-6 min/2-4 min
40 mm: 30 kN, 4-7 min/3-5 min
50 mm: 50 kN, 5-9 min/4-6 min
Cure at 160 – 180 ℃, 250 bar, high cooling rate.
If the mount is not fully cured, increase time.
The parameters above can vary a lot depending on the characteristics of the mounting press used.
1 kg, 7,5 kg
Akasel is a Danish company dedicated to developing, producing and distributing high-quality consumables and optimised preparation methods for metallography. Akasel was founded in 2004 by Morten Damgaard and is now present in more than 30 countries through a network of highly competent dealers.
Akasel is the smarter alternative because we pay special attention to our customers, developing high-quality consumables to help the labs achieve optimum preparation results and maximum reproducibility.
We will get back to you as soon as possible. The typical response time is 2 work days.